CRUS

Neue Basen starten

http://www.mersenneforum.org/showthread.php?t=12984

riesel-basexxx.txt Inhalt (Riesel Base -1)

DIM base, 858 //neue Base
DIM type, -1 //Riesel -1, Sierpinski 1
DIM min_k, 1
DIM max_k, 24052 //conjecture max siehe link oben -1
DIM max_n, 2500 //max n, bleibt so

https://www.mersenneforum.org/showthread.php?t=12983

sierp-basexxx.txt Inhalt (Sierpinski Base +1)

DIM base, 858 //neue Base
DIM type, 1 //Riesel -1, Sierpinski 1
DIM min_k, 1
DIM max_k, 24052 //conjecture max siehe link oben -1
DIM max_n, 2500 //max n, bleibt so

WINPFGW commandline

riesel-basexxx.txt -f100 -l (-l = output logfile, nicht unbedingt erforderlich, nimmt viel Speicherplatz in Anspruch je nach Größe)

Output -->Verbose -->Superquiet

Starten -->rechnet bis n=2500

srbsieve

1. preparing a new base

srbsieve.ini for initial start

base=660 //base mink=1 maxk=74030 //maxk-1 for creating the files for the hole base c=1 /+ for Sierpinski / - for Riesel Base maxNfbncsieve=8 maxKsrsieve2=1000000 phase=100 //n-value //phase=250 //phase=500 //phase=1000 //phase=2500

2. for multiple workers, copy pl_remain.txt into every folder 2,3,4 ... and adjust mink and maxk (10001-20000, 20001-40000 etc.)

srbsieve.ini for multiple workers

base=660 //base mink=10001 //from maxk=20000 //to c=1 // Sierpinski / - for Riesel Base maxNfbncsieve=5 maxKsrsieve2=1000000 phase=100 phase=250 phase=500 phase=1000 phase=2500

3. run srbsieve.bat from every folder to start from phase 2 because phase 1 was already done

4. If all workers are done, merge the content of all pl_remain.txt files to one pl_remain.txt and copy to initial folder, merge the content of all pl_prime.txt including initial folder to one pl_prime.txt

5. run srbverify using the original srbsieve.ini file. This will verify that all k are accounted for. It will also sort pl_remain.txt and pl_prime.txt by ascending k.

You can restart from the last checkpoint if there was something unexpected.

wird noch überarbeitet und in Deutsch sobald der Editor wieder angezeigt wird.